How to Run an Electrical Wire

Running an electrical wire is needed in order to move the electricity from its source at the service panel going to its destination, which can be an outlet, light, etc. The wire is the most important link that forms a network from a single starting point towards the various and scattered points in your home.

So here’s how you can run a electrician in Pasadena CA wire:

Open Up the Wall

If the wall is closed, you need to cut through the first layer of the drywall in order to get into the wall. Mark a straight line from the electrician Pasadena source going to the destination. Your goal should be to cut as little drywall as possible.

To ensure safety, turn the circuit breakers off. Then use an electric or manual saw to cut out the section of the drywall you marked. Set aside the cut section since you’ll be using this later to repair the wall.

Choose an Auger Bit

For the 14 or 12 gauge wire, a 3/8 inch or ½ inch auger or spade mounted on a drill is enough to provide space to pull the wire through. Avoid doing larger holes as this could compromise the stud’s structural integrity. On the other hand, smaller holes will make it hard for the wire to pull through.

Bore the Holes

Attach the auger bit to your drill and start driving a hole within the sides of all studs within the intended electrician Pasadena CA run. When you’re drilling holes, make sure you follow a straight line. Deviating from the straight line can make the pull more difficult. Clean the sawdust and wood chips afterward using a vacuum.

Run the Electrical Wire

Before you pull long stretches of wire, you must first straighten the coil out. By doing so, you’ll not be fighting a tightly bound wire in a coil and the pull will go much smoother.

Basically, you don’t want to have a lot of excess wire hiding inside your walls, although it’s good if you’ll leave a bit of slack in the wires just in case you need to adjust the box.

Install Nail Guards

Place metal nail guard plates above the edges of the studs to keep the drilled hole protected, including the wiring that’s inside it. This isn’t really required by the code, for as long as there’s enough distance between the wire and the edge of the stud.

Close Up the Wall Again

If you want to insulate the wall before you install the drywall again, make sure you leave enough slack at the wiring that’s between the studs so there won’t be any tension if the insulation is placed. The insulation is usually sliced in order for the Pasadena electrician wiring to be encased into it. However, it’s best to check with the insulation’s manufacturer before you do so.

Repair the section of the drywall by blocking the studs with scrap wood in order to support the patched section. Attach the patch using drywall screws and apply the drywall compound to the area. Tape it and leave it to dry.