The ease of an automated garage-door opener has created this this product a common feature in several homes; the press of a button will increase and lower the door for quick entry. Two sensors reside on each aspect of the garage-door, usually clipped to the sidetracks of the door. These sensors respond when they instantly open the door and discover an obstruction in the Garage-door pathway. Re-aligned and the sensors, nevertheless, might require to be changed occasionally, particularly with an opener program that is older.
Eye Elimination
Turn off the circuit-breaker in the main panel that supplies energy to the garage-door opener. Use a non-contact circuit tester system in the panel to confirm that energy continues to be effectively shut down.
Access the motor device using a ladder of the opener. Locate the black and white wires entering the motor in the two independent automated eyes. Each eye has two wires.
Press the fast link tab keeping the wires that are black using a flathead screwdriver to produce the wires. Pull the wires that are black out.
Repeat Step 3 for the tab keeping the white wires.
Untwist the introduced black wires to ensure the two independent automated eyes aren’t linked in the finish of the wire. Repeat the untwisting for the wires that are white. Allow the wires to to hold briefly.
Detach each of the staples over the ceiling keeping the white and black wire configuration to the automated eye requiring elimination using a big staple remover of the garage.
Detach the mounting bracket from the monitor of the garage door of the eye. The bracket should be an easy clip which can be pulled with all wiring and the eye connected to it.
Hand-loosen the wing nut that retains the eye. Remove the eye in the bracket with its carriage bolt that is provided.
Installing New Eye
Slide the carriage bolt from the rear keeping location of the aged eye. Slide this carriage bolt onto the eye that is new.
Place the bolt and eye configuration on the bracket and hand-tighten the wingnut on the bolt to secure the eye.
Push the bracket’s clip a-T roughly 6″ over a floor on the Garage-door track.
Strip 7/16 inch of insulation off the ends of the black wires white and on the the with wire strippers. of new ‘s Press the wiring from the wall of the garage and secure with insulating a staple gun and staples a-T every 1 2-inch interval. Continue to connect the wiring before the over-head garagedoor opener motor is reached by the wiring.
Hand-twist the black wire ends from each automated eye and drive them to the specified fast link relationship level until an audible “click” happens to denote their appropriate positioning.
Repeat Step 5 for the wires that are white.
Turn the circuit-breaker straight back on in the principal panel.
Hand-loosen the wing-nut on the eye that is new. Slightly shift the eye about in its position that is loosened in order that it becomes parallel together with the eye over the garage doorway. Equally eye sensors should have their personal lights lit, when the eyes become parallel.
Hand- once the lights illuminate, tighten the wing-nut. Ensure the procedure that is tightening doesn’t knock the eye from alignment by observing the indicator mild.
Press the garage-door opener button and check the motion of the door’s down and up.