How to Match Textured Ceilings

Finish textures, both in interior and exterior settings, cover a surface in a specific style. These include slap brush methods, knockdown cutter and knife textures. While meant to continue over the years, excessive motion and individual error during setup may result in cracks and other problems requiring repair. Matching ceiling textures allows you to patch an area so it fits seamlessly with surrounding regions.

Nature of Debate Mud

One important facet of texture mud is it breaks out if it is allowed to dry quickly and if the layers of mud are overly thick. When matching texture, remove the cracked-out or otherwise damaged old layer. From there, check how thick the current texture layer is. If you are up against a texture that is just 1/8 to 1/4 inch thick, then one layer of mud could be applied. Anything heavier requires 2 or possibly even three distinct coats, with each degree no longer than 1/4 inch thick.

Testing Processes

Textures are usually applied initially by professionals with years of expertise. The average homeowner, lacking these skills, will find it hard to match an present texture finish on the first try. Since you want the new end to match the old texture, master the numerous textures ahead. Always test your finishing techniques on a scrap piece of timber or other area in which you control the texturing and experiment with techniques and tools until you achieve your goals. A knife texture, for instance, is applied with a putty knife, but till you test your knife-texturing skills, it is not a good idea to apply mud straight away to your surface. A swirl brush is used to make a swirl texture using drywall mud.

Application

Prior to applying a layer of texture mud on the surface of the area, dampen it with a fine misting of water. This helps bond the new feel to the current texture and surface, in addition to help prevent cracking. After application, the patch ought to be misted again using a fine layer of water and covered vinyl for five to seven days to slow drying and prevent cracking. For best results, put in a slight misting of water every 24 to 48 hours to maintain the feel mud drying slowly. If you need to add multiple layers, this is a process which takes a few weeks.

Coloring

The one thing about texture mud is you’ll never have the ability to match the coloring and texture of the original application exactly. With respect to colours, dyes and pigments are added to stucco to make hues of your layout, however over time all colours fade, which means an present texture which has had 10 years to fade will look different than your patch. Painting the end surface conceals this inconsistency. Pure textures, on the other hand, will always look somewhat different than the current texture. Concrete paints and stains are also available for mortar-based stuccos.

See related